Cisco 220 access http disabled

[adeebtaqui]

Hi,

After I was configuring cisco sg220-50P, I could not access the switch through browser by its management IP nor is ping reaching through cmd.  

How to enable HTTP to access the GUI browser?

#sh line list
Line Type | AAA Type | List Name
-------------+-----------------+-----------------
console | login | default
| enable | default
telnet | login | default
| enable | default
ssh | login | default
| enable | default
http | login | default
https | login | default

[Mark Malone]

Hi

page 575

https://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbss/sf220_sg220/command_line_reference/Sx220_CLI_Guide.pdf

Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x471

Web Server Commands

ip http secure-server To enable the HTTPS service on the switch, use the ip http secure-server Global Configuration mode command. To disable the HTTPS service on the switch, use the no form of this command.Syntaxip http secure-serverno ip http secure-serverParametersN/ADefault ConfigurationThe HTTPS service is enabled by default. Command ModeGlobal Configuration modeExampleswitchxxxxxx(config)# ip http secure-serve

[marce1000]

 - Resolve the ping issue first and or set correct network-address and related parameters.

    M.

[adeebtaqui]

Why is http and https shown as disabled?

[Mark Malone]

its enabled by default , did someone switch it off ?

[adeebtaqui]

Yes it was before as i could access the gui through google chrome.

But later after cli configuration to make it faster; i could not access the gui on Google or other browser.

On cli i cannot find how to correct or enable this