Cisco 2600 IOS upgrade problem

[siddhesh.bane]

I have uploaded new IOS image on my 2600 series router. But now my router doesn't come up.

During uploading image it asked to erase the flash but i given "NO" & uploaded image.Image uploaded successfully. after that i given command " boot system flash imagename".

Write the configuration.

Then reload. But its not coming UP now.

Please help me.

[ankbhasi · Accepted solution]

Hi Siddesh,

Can you console into the router and update the present status as what do you see? Is it in rommon? Is it in continuous booting loop?

Regards,

Ankur

[siddhesh.bane]

Hi Ankur,

Thanks for ur reply, I am facing prob with console cables over my remote location. I have arranged cables to send there. After that only i can update u.

Can i physically come to know that router is in continuous booting loop? That means LED Indicators??

Thanks Again

[siddhesh.bane]

Ankur,

Thanks for reply.Problem has been resolved .It was going in initial setup mode & bypassing startup-config.I don't know why?. But same has been fixed also with IOS upgradation so that i can use cryptographic features.

Anything from which will going to update my knowledge is highly accepted & Expected.

Thanks Again.