cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1900
Views
0
Helpful
4
Replies

CISCO 2811 PASSWORD RESET

alexa
Level 1
Level 1

hello all-

 

i have a cisco 2811 i dont know the password that was set previously i was able to reset the router password, and gained access to it, but how do I reset the password on the service module?  Any assistance would be appreciated it.  

 

thanks

 

 

1 Accepted Solution

Accepted Solutions

Peter Paluch
Cisco Employee
Cisco Employee

Hi,

What kind of service module is that? These may have different password recovery procedures depending on their type.

At least for NM-WLC6, the following steps were required:

  1. Configure the interface wlan-controller or interface service-module with an arbitrary valid IP address, say, 10.0.0.1/24, and no shutdown it.
  2. Follow the steps in http://www.cisco.com/c/en/us/support/docs/wireless/2000-series-wireless-lan-controllers/71094-wlcm-pwr.html

Best regards,
Peter

View solution in original post

4 Replies 4

Peter Paluch
Cisco Employee
Cisco Employee

Hi,

What kind of service module is that? These may have different password recovery procedures depending on their type.

At least for NM-WLC6, the following steps were required:

  1. Configure the interface wlan-controller or interface service-module with an arbitrary valid IP address, say, 10.0.0.1/24, and no shutdown it.
  2. Follow the steps in http://www.cisco.com/c/en/us/support/docs/wireless/2000-series-wireless-lan-controllers/71094-wlcm-pwr.html

Best regards,
Peter

i have a NME-16ES-1G-P Modudel

Nadeem Ahmed
Cisco Employee
Cisco Employee

Hello Alexa,

 

Are you being asked for a username/password after "service-module service-enging 0/0 session"? If so, check the line for the CUE module. In your router config, along with "line vty 0 4", etc you will have something similar to "line 194". Is this line set to require a login? If so, remove the login command.

 

also check below thread if this help

 

https://supportforums.cisco.com/document/93176/password-recovery-waas-installed-sre-module

 

Br,

Nadeem

Br, Nadeem Please rate all useful post.

i added this line and still nothing

 

transport output lat pad telnet rlogin lapb-ta mop udptn v120 ssh
line vty 0 4
 no login
 transport input all

Review Cisco Networking for a $25 gift card