01-14-2016 12:07 AM - edited 03-08-2019 03:24 AM
Hello everyone. I want to avail a DS3 service using CISCO 2851. Well, I had inserted a T3/E3 card in that router tried following IOS but didn't find any other interface except two GE & one FE.
1. c2800nm-advipservicesk9-mz.123-11.T3.bin
2. c2800nm-adventerprisek9_ivs-mz.151-2.T2.bin
3. c2800nm-ipbasek9-mz.151-4.M3.bin
There are two default IOS in that router
1. c2800nm-advipservicesk9-mz.151-4.M8.bin
2. c2800nm-advipservicesk9-mz.151-4.M9.bin
Can anybody please suggest me any other IOS so that I can use T3/E3 card for the service.
Solved! Go to Solution.
01-14-2016 01:00 PM
Hi,
In order to recognize the card you need to configure your router via the "card type t3/e3 1" configuration command as suggested during boot. Just after that you should see the new interface displayed. You can try with one of your default IOS.
Best regards,
Antonin
01-14-2016 01:00 PM
Hi,
In order to recognize the card you need to configure your router via the "card type t3/e3 1" configuration command as suggested during boot. Just after that you should see the new interface displayed. You can try with one of your default IOS.
Best regards,
Antonin
01-19-2016 10:34 PM
Thanks Antonin. It helped a lot.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide