05-06-2019 08:07 AM
Hi,
We have recently installed a Cisco WS-C2960L-SM-24TS 15.2(6)E2b.
For reminder, the switch is configured on Web interface and cli on read only.
I have configured a port in access mode vlan 7 and then moved it to trunk.
The issue is that on cli, i can see both configuration on the interface and no way to clear it:
interface GigabitEthernet0/22
switchport access vlan 7
switchport mode trunk
!
On the web interface: it is trunk.
Solved! Go to Solution.
05-07-2019 12:09 AM
Hi Reza,
Thanks for your reply. The solution makes sense except the catalyst 2960 is a smart switch. The CLI is in read only and the configuration is done on web.
Since the switchport access vlan 7 does not impact the trunk operation, then there is no issue.
Thanks
05-06-2019 08:08 AM
05-06-2019 11:55 AM
Hi,
The additional command does not harm anything. Not familiar with the Web interface but on the cli, you can negate vlan 7 (no switchport access vlan 7).
HTH
05-07-2019 12:09 AM
Hi Reza,
Thanks for your reply. The solution makes sense except the catalyst 2960 is a smart switch. The CLI is in read only and the configuration is done on web.
Since the switchport access vlan 7 does not impact the trunk operation, then there is no issue.
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: