cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
990
Views
5
Helpful
4
Replies
Highlighted
Beginner

CISCO 2960 %SUPQ-4-CPUHB_RECV_STARVE ERROR

Hi,

I'm using a cisco switch WS-C2960-8TC-L which is showing this error message several times almost every day:

%SUPQ-4-CPUHB_RECV_STARVE: Still seeing receive queue stuck after throttling.

I have lost connectivity with it several times, Is it related with this error?

The switch is attached to an identical switch by port fastethernet 0/8. It also has two other ports attached to PCs but they have been in a not connect state all this time.

The IOS software in the device is: Version 12.2(35)SE5, RELEASE SOFTWARE (fc1)


4 REPLIES 4
Highlighted
Cisco Employee

Hello Ivanka,

This is a well known bug in 12.2(35)SE5.  Please have a look at the info below and also the link that will explain it in more detail.  I would recomend looking at an upgrade path as 12.2.(35)SE5 is qutie old (2007) and we have fixed many bugs and defects since then.

Bug ID: CSCsx29696

Symptom:
Connectivity issues, with following messages.
%SUPQ-4-CPUHB_RECV_STARVE: Still seeing receive queue stuck after throttling
Conditions:
The "cpu-queue-frames" section of the output of "show controllers cpu-interface" command needs
to show non-zero counts for one or more queues in the "hol-block" column; otherwise, the
system is having some other problem.
This problem may affect switch platforms other than the Catalyst 3750, including the 2960, 2970,
and 3560.
Workaround:
None.

Reference:

https://tools.cisco.com/bugsearch/bug/CSCsx29696/?reffering_site=dumpcr

HTH

Luke

Highlighted

Thanks a lot for your help. It's really useful information.

I checked that the "cpu-queue-frames" section of the output of "show controllers cpu-interface" command shows zero counts for all queues in the "hol-block" column. Is it a symptom of another problem? Would be an upgrade enough to solve all these problems?

Thx.

Highlighted
Beginner

After upgrading to the latest ios version (15.0(2)SE5) I'm still having the same problem.

The "cpu-queue-frames" section of the output of "show controllers cpu-interface" command

shows zero counts for all queues in the "hol-block".

Highlighted
Beginner

HI All,

I have de same problem on two 2960X stack.

The firmware that not contain the problem is Version 15.2(4)E8.

All Version after this release cause the problem for me.

 

We plan to buy another vendor because CISCO support is easy.

 

Thanks!

 

Content for Community-Ad