Ran those alerts through the output interpreter , see below could be a bug i would TAC it to be sure
ERROR MESSAGE NOTIFICATIONS (if any)
Explanation: The error message SUPQ-4-CPUHB_RECV_STARVE will be displayed
for the following conditions:
1. The issue mentioned in the Bug tool kit for the Bug ID CSCed03214.
2. The device may receive a "1-byte frame" (i.e. Start of Frame Delimiter (SFD)
followed by one byte of data followed by End of Frame Delimiter (EFD)) under the
following known network conditions.
- Collisions on a 10 Mbps, half-duplex interface
- Unplugging the cable after the 1st byte is received
- Physical layer problems on a 1000Base-T SFP port
- Receiving packets at 10 Mbps or 100 Mbps from a device that generates nibble-aligned
preambles
Due to a hardware issue, the "1-byte frame", which is an invalid Ethernet packet,
is passed on to the forwarding logic instead of being dropped by the MAC. This
can cause pointers in the RxPortFifo and/or RxBuffer of the ingress ASIC may get
corrupted and locked up.
Recommended Action: Hardcode the duplex and speed as mentioned in the above Bug
ID. Also, upgrade your device with the latest version of the software as mentioned
in the Bug release note. If the error message display persists, you may need the
hardware replacement. Open a service request with Cisco at TAC Service Request
Tool.
The submitted error message(s) were not found. New error messages are added each
month, check back frequently to see if your error message has been added.
No information on error code SUPQ-4-PORT_QUEUE_STUCK
Cisco PDF output
Error Message
SUPQ-4-CPUHB_RECV_STARVE: [chars]
Explanation
This message means that the system has detected that messages directed to the CPU are
delayed.
[chars] is the detailed error message.
Recommended Action
Copy the error message exactly as it appears on the console or in the system log,
call your Cisco technical support representative, and provide the representative with the gathered
information.
Error Message
SUPQ-4-PORT_QUEUE_STUCK: Port queue Stuck for asic [dec] port [dec]
queue [dec]
Explanation
This message means that the system has detected that an interface queue is not being
cleared in a reasonable time. The first [dec] is the ASIC, the second [dec] is the interface, and the
third [dec] is the queue number.
