cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

1890
Views
0
Helpful
4
Replies
Highlighted
Beginner

Cisco 2960X QinQ Supported?

Hello, 

Would anyone happen to know if QinQ is supported for Cisco 2960X Switches running the latest version of IOS? I have performed a quick search through the Configuration Guide for the latest IOS release however I do not see any information regarding QinQ being supported for the 2960X.

I found a Support thread that did indicate it is not supported for the 2960X model however I did not see any Cisco documentation that indicated that was the case.

(Link to Support thread - https://supportforums.cisco.com/discussion/12927511/qinq-2960-xxr)

(Link to the latest 2960X Configuration Guides - http://www.cisco.com/c/en/us/support/switches/catalyst-2960-x-series-switches/products-installation-and-configuration-guides-list.html)

Thank you,

Zack

4 REPLIES 4
VIP Mentor

I don't see it either under

I don't see it either under the data sheet for 2960x models as a supported feature and that was last updated this month

http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-2960-x-series-switches/data_sheet_c78-728232.html

VIP Advisor

Hi

Hi

Check this link and search by Q-in-Q VLAN Tunneling

http://cfn.cloudapps.cisco.com/ITDIT/CFN/jsp/by-feature-technology.jsp

I think it is not supported on 2960 serial models. 

Hope it is useful

:-)

VIP Expert

Hi Julio,

Hi Julio,

This is the same link the OP posted :-)

Reza

VIP Advisor

Hi

Hi

I have verified on one of my Cisco switches 2960X and it is not supported:

Switch details:

WS-C2960X-24TD-L
IOS 15.0 

ABCDE(config-if)#switchport mode ?
access Set trunking mode to ACCESS unconditionally
dynamic Set trunking mode to dynamically negotiate access or trunk mode
trunk Set trunking mode to TRUNK unconditionally

Hope it is useful

:-)

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards