cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

101
Views
0
Helpful
1
Replies
Highlighted
Beginner

Cisco 2960X with IOS 15.2: Adding IPv4 and IPv6 ACL to SNMP community at the same time

Dear Forums,

I'm currently configuring a bunch of Cisco 2960X switches and would like to secure access to SNMP for IPv6 and IPv4 with the following commands:

#snmp-server community public ro ipv6 ipv6-acl
#snmp-server community public ro ipv4-acl

However, only the last command I entered is added to the configuration so I've the choice between securing the community with an IPv4 or IPv6 ACL. Is this by design or is there another way to apply both IPv4 and IPv6 ACLs at the same time to the SNMP community?

Thanks,
Michael

Everyone's tags (3)
1 REPLY 1
VIP Advisor

Hello

Hello

You may need to change the SDM platform of the switch to accommodate ipv6

sh sdm prefer

res
Paul



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future
CreatePlease to create content
Content for Community-Ad