04-18-2012 01:56 AM - edited 03-07-2019 06:11 AM
Good morning,
I'm trying to access the swith to erase all users IP information for each line etc,
I've run the following commands
flash_init
load_helper
boot
The switch reboted ok but i cannot access the switch as it has a motd banner and login, how do i go about removing the banner and login so i can reset the switch
Regards
Paul
04-18-2012 01:58 AM
Opps sorry almost forgot
I dont have access the user login or password information
paul
04-18-2012 02:02 AM
Hi Paul ,
The easy way is to hold the button on the from panel for some time. This will automatically do password recovery.
If you want to do it manualy, after load_helper you should rename the startup config :
rename flash:config.text flash:config.text.old
and after that boot.
Dan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide