Cisco 3550 IOS - VLANs and SNMP for Network Traffic Issue
I am just starting out learning Cisco with my web hosting company I just started in December. I am having an issue with VLAN interfaces not recording traffic though SNMP I am using Cisco IOS EMI 12.1. Cacti usually shows an empty white space or a little traffic here and there. But I don't think it is an issue with cacti. Running layer 3/static routing on this vlan interface. Below is show int Vlan command (in case its usefult to resolve my issue):
edge2.dtw1.d10net.net#show int Vlan51
Vlan51 is up, line protocol is up
Hardware is EtherSVI, address is 0016.c739.af80 (bia 0016.c739.af80)
Internet address is 126.96.36.199/29
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:01, output 00:00:20, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 4
Purpose of the documentReference TopologyUse-CaseSymptomDiagnosisSolutionAdditional References
Purpose of the document
This document describes the general recommendations or best practices when designing and deploying the Cisco SD-Access technology. The ...
Dear All, When I use the show interface command on the Cisco Router ISR-4331, it will display as below information. The word that I mark red, it refresh every 5 seconds. But, I compare with the old router model like a Cisco 29XX or 28X...
Whether you're attending VMworld 2019 on-site or from afar, read the latest on the key themes to expect. They are also the key themes for IT management today, from software defined everything to cloud and automation to IoT and edgecomputing : http:...
To participate in this event, please use the button to ask your questions
This topic is a chance to discuss more about SD-WAN), it's foundations and inner mechanisms as well as its correct design a...