Cisco 3750 Stack Preemption
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-26-2011 08:39 AM - edited 03-07-2019 01:55 AM
Hi All
I have a stack of 5 switches and have configured switch 1 as master however i want to setup some preemption feature for it incase if sw1 reloads it should become master again.
i have read on cisco site that there is a way to do it however conud not find it..
thanks
Oriel
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-26-2011 09:58 AM
Oriel,
I don't think this is possible. If I look at the priority values for master election, it is from 1 to 15.
Even if you assign 1 to a switch, this switch can become master if there are no competing members in the stack. There is no Preemption in Master election as well. So, this is not possible.
Regards,
Amit
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-26-2011 12:07 PM
Hi Oriel,
Once there's an active switch elected in the stack, there's no preemption. You can configure each member with a priority value from 1 to 15.
Please review the following documentations for more details, examples and frequently asked questions.
Creation and Management of Catalyst 3750 Switch Stacks
Managing Switch Stacks
Best regards,
Andras
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-30-2011 02:21 AM
Yes this is what i understand however i have seen it somewhere in cisco documentation that preemption is possible.
Let me find out that doucment and i will get back to you guys.
thanks for your help.
Oriel X
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-30-2011 03:05 AM
And can you guys please tell me how i can ask a new quesiton.
I am trying to start a private discussion and its asking me to select the people which i dont want.
i want to ask everybody just like i asked this question.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-30-2011 03:29 AM
After selecting the topic where you want to post, you'll need to click "Start a discussion" in the Actions pane on the right hand side.
Andras
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-30-2011 06:17 AM
I am sure there is no preemtion possible...Only way to do is the reload the newly elected master,after the old master comes up..This will retrigger the election,and old master will win
