09-24-2019 06:33 AM
Good morning,
we recently installed a stackwise-virtual of two Cisco 3850-48XS-E with SW Ver. 16.6.4 but we see several interfaces drops.
In the logging I find the following message:
%PLATFORM_MATM-4-QUEUE_OVERLIMIT: MATM dropped learn cache batch messages as queue limit has reached.
Is there a correlation between the drops and the log error message?
Attached show interfaces with drops.
thanks
Marco
09-24-2019 06:50 AM
Hi,
Can you check your CPU uses as well? Is it updated IOS version? Please check a document:
09-25-2019 02:58 AM
09-26-2019 12:45 AM
09-26-2019 01:27 AM
@mtaddia wrote:
we did not implement any qos policy
Unlike the Catalyst 2960, 3560/3750 (where they can operate without QoS), 3650/3850 REQUIRES QoS.
Unfortunately, the QoS configuration for the 3650/3850 is very unforgiving. If the configuration is off by a tiny mark you will get packet drops.
11-01-2019 09:27 PM
Hi Leo, Do you know how to config minimum qos so that 3850 can work well, because I don't need qos actually.
09-26-2019 12:54 AM
Hello,
try and globally configure:
qos queue-softmax-multiplier 1200
on the switches that have interfaces with output drops...
09-30-2019 06:08 AM
Thanks a lot Georg with the "qos queue-softmax-multiplier 1200" command, the reporting of the total output drops has almost disappeared on almost all the interfaces of the affected switches. Unfortunately, on some backbones, output drops persist even if much less than before. Do you have any suggestions? Thanks again.
Marco
11-01-2019 08:05 PM
Hi , mtaddia, I have the same problem with you . Have you solved the problem finally?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide