I am new to this BDI thing on the new IOS...
I am trying to setup a layer 2 SM switch module up on a 4451.
I have a PC plugged into vlan666 and I can ping the router interface 10.16.202.1 but not the switch at 10.16.201.2.....
I cant get it to work. here is the configuraiton of the switch and the router...
What am I doing wrong....
*****4451 Router......
version 15.4
interface Ethernet-Internal1/0/0
no negotiation auto
service instance 1 ethernet
encapsulation untagged
bridge-domain 1
!
service instance 666 ethernet
encapsulation dot1q 666
bridge-domain 666
!
!
interface Ethernet-Internal1/0/1
description for module to module traffic only
shutdown
no negotiation auto
switchport mode trunk
!
interface BDI1
ip address 10.16.202.1 255.255.255.252
!
interface BDI666
ip address 172.16.255.1 255.255.255.240
encapsulation dot1Q 666
!
*****Service Module
version 15.2
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
interface GigabitEthernet0/1....22
!
interface GigabitEthernet0/23
switchport access vlan 666
spanning-tree portfast
!
interface GigabitEthernet0/24
switchport access vlan 666
spanning-tree portfast
!
interface GigabitEthernet0/25
switchport protected
!
interface GigabitEthernet0/26
switchport trunk encapsulation dot1q
switchport mode trunk
switchport protected
!
interface Vlan1
ip address 10.16.202.2 255.255.255.252
!
interface Vlan666
ip address 172.16.255.2 255.255.255.240