05-03-2012 11:24 PM - edited 03-07-2019 06:30 AM
Hi all.,
Does anyone know what is causing " Gigabit port is restricted to full duplex" while trying to hard code speed/duplex on a 4507 switch port?
Thank you,
Marian
05-04-2012 12:49 AM
This means that 1G/Half-duplex mode is not implemented in Cisco. Not only in Cat4507 but in any other switch also, despite of a fact that such a standard does exist.
05-04-2012 06:42 AM
Marian,
Some older modules don't support setting half-duplex. Newer ones do.
As an example older module that does not support setting half-duplex = WS-X6316-GE-TX. A newer module that does = WS-X6148A-GE-45AF
Dan
05-04-2012 09:15 AM
Thanks Sergey and Dan. I have a pair of 4507, HSRP config (same hardware different IOS though). The issue I have is only on the switch with the oldest IOS release (active HSRP), when I tried to config "duplex full".
Marian
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: