10-19-2011 05:12 AM - edited 03-07-2019 02:54 AM
Good Morning,
we have to replace the sup720 of a vss bundle.
I've read the how-to on cisco.com web site:
http://www.cisco.com/en/US/products/ps9336/products_configuration_example09186a0080a64891.shtml
but I have some questions about the replacement:
When we perform the recovery procedure is likely to malfunction despite one of the two nodes VSS is currently up and running?
What kind of impact we can have?
May occur during recovery procedure a fault on the running machine?
In the event of a fault which these cases the recovery process and especially the estimated timing?
Note: We have a VSS with FWSM (one for each 6509) and with WISM (two for each 6509).
Thanks a lot
Leonardo
10-20-2011 01:31 AM
Jon we have these two images:
s72033-adventerprisek9_wan-mz.122-33.SXI4.bin
s72033-adventerprisek9_wan-mz.122-33.SXI3.bin
There was a blackout in our enviroment...but this VSS never gave us problems!!! I suppose for a faulty supervisor but...at this point...i don't know...
Anyone can help me?
10-20-2011 03:43 AM
Leonardo
But which one of those images is the active supervisor running, ie. you copied SX14 but is your active supervisor running SX13 ?
Jon
10-20-2011 04:02 AM
the SXI4 one is running...
10-20-2011 05:07 AM
Leonardo
If you are sure the image is compatible then have a look at this link -
it may help.
Jon
10-20-2011 05:12 AM
I have already red that page...but I've not gave that error... I don't know if is correct to deploy that synch in this case.
10-20-2011 01:58 PM
Both Supervisor cards need to run the same IOS version and same feature set.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide