08-14-2019 02:53 AM - edited 08-14-2019 03:22 AM
hi all,
i want to make a switchport back to access from a fabric extender
i have done the command -
default int eth9/13
int eth9/13
switchport mode access
switchport access vlan 110
no shut
but its still showing up as a FEX port, how can i change this please
many thanks,
rob
EDIT - i have a feeling there actually different connectors?
Solved! Go to Solution.
08-14-2019 09:47 AM
Yes, if you take the SFP out, you should see the word FET somewhere on it.
HTH
08-14-2019 08:15 AM
Hi,
Can you post the output of "sh interface ethernet 9/13 status"?
HTH
08-14-2019 08:22 AM - edited 08-14-2019 08:23 AM
sh interface ethernet 9/13
Ethernet9/13 is down (Transceiver validation failed)
admin state is up, Dedicated Interface
Hardware: 1000/10000 Ethernet, address: e4c7.220a.a390 (bia e4c7.220a.a390)
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, medium is p2p
Port mode is access
auto-duplex, auto-speed, media type is 10G
Beacon is turned off
Auto-Negotiation is turned on
Input flow-control is off, output flow-control is off
Auto-mdix is turned on
Rate mode is dedicated
Switchport monitor is off
EtherType is 0x8100
EEE (efficient-ethernet) : n/a
Last link flapped 63week(s) 5day(s)
Last clearing of "show interface" counters 64w1d
1 interface resets
08-14-2019 08:55 AM
Ethernet9/13 is down (Transceiver validation failed)
What are using to connect this interface? Are you using a FET (Fabric Extender Transceiver) or a standard optic.
If you are using a FET that is the reason you see the port type is "Fabric Exte"
HTH
08-14-2019 08:59 AM
ohhhh is that the reason why as fabric and 10gig module sfps are totally different?
i cant actually get the module out to look as its stuck
08-14-2019 09:47 AM
Yes, if you take the SFP out, you should see the word FET somewhere on it.
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide