Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
342
Views
0
Helpful
1
Replies

Cisco 877W - Cant get DHCP through to Fa0 wi WLAN enabled

tinochelli
Level 1
Level 1

‎03-09-2011 02:43 PM - edited ‎03-06-2019 04:00 PM

Hi,

Looking for a bit of assistance here in which I am hoping will be a simple resolution.

I have an 877W which is currently configured for a wireless network connected to an ADSL line.  This portion is all working well.

However when I connect a device into one of the switch ports I am not getting a DHCP assigned address from the configured scope.

I have attached the config and ommitted some of the config that is not of concern such as ACLs and crypto maps. 

I I have tried adding an ip helper-address command to VLAN 1 pointing it to 192.168.10.1 but this has not worked.

Any suggestions would be greatly apprecaited

Thanks,

Labels:
83023-Test Config.txt.zip
0 Helpful
1 Reply 1

tinochelli
Level 1
Level 1

‎03-09-2011 02:55 PM

I was perhaps a little quick to post on here....

I have found the issue.....I was missing the bridge-group 1 command from vlan 1.  Added that and all is working

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card