Cisco 887va-k9 what router can replace this , was thinking an 1921

[sblackman68]

Hi I have a dead 887va router, needs  a K9 code what router could replace this which is slightly better spec, but do the same job. ie. ADSL etc.  These interface:-

controller VDSL 0

!

!
interface Loopback0
ip address 10.25.254.49 255.255.255.255
no ip redirects
no ip unreachables
no ip proxy-arp
!
interface ATM0

!
interface ATM0.1 point-to-point
pvc 8/35
pppoe-client dial-pool-number 1
!
!
interface Ethernet0
no ip address
shutdown
!
interface FastEthernet0
no ip address
!
interface FastEthernet1

!
interface FastEthernet2
no ip address
shutdown
!
interface FastEthernet3
no ip address
shutdown
!
!
interface Dialer1

Cheers,

Scott.

[Mark Malone]

Hi
CISCO 1900 series maybe the next step up for you , its the next series from 800 after that would be 4k router, supports VDSL and ADSL too but you may have to get a module with it

https://www.cisco.com/c/en/us/products/routers/1900-series-integrated-services-routers-isr/index.html

https://www.cisco.com/c/en/us/products/collateral/routers/3900-series-integrated-services-routers-isr/data_sheet_c78-644629.html

[sblackman68]

Hi, many thanks was thinking of 1921 router do you know what additional modules I would need , show ver of current router

Cisco C897VA-K9 (revision 1.0) with 488524K/35763K bytes of memory.
Processor board ID FCZ2118E027
1 DSL controller
1 Ethernet interface
9 Gigabit Ethernet interfaces
1 ISDN Basic Rate interface
1 ATM interface
1 Virtual Private Network (VPN) Module

[Mark Malone]

Hi you just need the adsl module rest is inuded

[Mark Malone]

Sorry lan mod 2, all mods here available in link

https://www.cisco.com/c/en/us/products/routers/1900-series-integrated-services-routers-isr/relevant-interfaces-and-modules.html

[sblackman68]

Hi will this one work? Cheers.

EHWIC-VA-DSL-A

√

√

√

Multi Mode VDSL2/ADSL/2/2+ EHWIC Annex A Data Sheet  Q&A

[Mark Malone]

Yes that does ADSL

You will need something for this too unless they were not in use and your using a switch locally
9 Gigabit Ethernet interfaces

[Joseph W. Doherty]

Have you looked at the ISR 900 or 1000 series?