cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
542
Views
0
Helpful
3
Replies

Cisco 9300L macsec config

fractal90
Level 3
Level 3

I want to config macsec between two 9300L, but when i started to config i noticed:

they don't have this command

9300_stack#show run interface gig 1/0/1
interface GigabitEthernet1/0/1
description MACSEC_manual_3850-2-gi1/0/1
switchport access vlan 10
switchport mode trunk
cts manual 
    no propagate sgt
    sap pmk AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA mode-list gcm-encrypt

 

Switch Ports Model              SW Version        SW Image              Mode
------ ----- -----              ----------        ----------            ----
*    1 29    C9300L-24P-4X      16.12.3a          CAT9K_IOSXE           INSTALL
1 Accepted Solution

Accepted Solutions

fractal90
Level 3
Level 3

it was a bug, i've updated to 16.12.04 and it's help

View solution in original post

3 Replies 3

marce1000
VIP
VIP

 

                      >....they don't have this command

 I don't understand, could you post config command as tried (exactly) , including returned error.

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !

it doesn't sap

 

 

switch(config)#int te 1/1/4
switch(config-if)#ct
switch(config-if)#cts ma
switch(config-if)#cts manual
switch(config-if-cts-manual)#?
CTS manual configuration commands:
  default    Set a command to its defaults
  encrypt    Pause frame encryption configuration for manual mode
  exit       Exit from CTS manual sub mode
  no         Negate a command or set its defaults
  propagate  CTS SGT Propagation configuration for manual mode

switch(config-if-cts-manual)#sap ?
% Unrecognized command
switch(config-if-cts-manual)#sap ?
% Unrecognized command
switch(config-if-cts-manual)#sap
                                        ^
% Invalid input detected at '^' marker.






 

fractal90
Level 3
Level 3

it was a bug, i've updated to 16.12.04 and it's help

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card