07-04-2012 03:06 AM - edited 03-07-2019 07:36 AM
Hi all,
I would like to get CbQos on a Cisco ASR 1002S (IOS-XE Software (PPC_LINUX_IOSD-IPBASEK9-M), Version 15.1(1)S1).
With the standard OIDs (cbQosIfIndex - 1.3.6.1.4.1.9.9.166.1.1.1.1.4), I can't...
So, is it possible ? If it is, which OID ?
Thanks in advance.
Regards.
07-04-2012 12:06 PM
HI,
PLease use below commands in ASR.
RTR(config)#configure terminal
RTR(config)#snmp-server ifindex persist
RTR(config)#snmp mib persist cbqos
Below is link for all the OID with CBQos.
http://www.oidview.com/mibs/9/CISCO-CLASS-BASED-QOS-MIB.html
Hope it helps.
Warm Regards
Ameya Oke
07-05-2012 03:22 AM
Thanks for your help Ameya,
Unfortunately for ASR router, the OIDs provided in your link are those I am currently using but the result is :
snmpwalk -v 2c -c SNMP_community IP_adress 1.3.6.1.4.1.9.9.166
SNMPv2-SMI::enterprises.9.9.166 = No more variables left in this MIB View (It is past the end of the MIB tree)
IOS is : IOS-XE Software (PPC_LINUX_IOSD-IPBASEK9-M), Version 15.1(1)S1.
So, is it particular for this kind of IOS to see COS by SNMP on ASR routers ? Is there another diffrent OID with CBQos for this IOS ?
Another idea ?
Thanks in advance.
Best regards.
07-20-2012 12:31 AM
UP
Any idea ?
Thanks.
09-02-2015 10:16 AM
Same here.
Did you found how to do?
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: