CISCO C1000-24P-4G-L PoE issue

[arun panengal]

The PoE is not working in all the 24 ports in the switch , getting an error message , "inline power denied,reason:insufficient total power available. Surveillance cameras are using as the end devices. Data is coming up in the affected ports.

Tried forcing the power to the ports , but still no luck

[Leo Laohoo · Accepted solution]

---

@arun panengal wrote:

insufficient total power available

---

It means the PoE budget has been maxed out. 

The output shows PoE port with "Power deny".  This is consistent with not enough PoE allowance left.

[arun panengal]

Thanks @Leo Laohoo  but it will be due to a bug in ios ? have tried with another switch , and got the same result.

[Leo Laohoo · Accepted solution]

---

@arun panengal wrote:

but it will be due to a bug in ios ?

---

No, it is not a bug.  

The PoE budget/allowance for each switch has been exhausted or ran out.

[arun panengal]

Thanks @Leo Laohoo  i have to use CISCO C1000-24FP-4G-L which will provide 370W power

[Kasun Bandara · Accepted solution]

Hi,

error means, your switches 195w total power budget is filled and no new devices allowed to use PoE power from switch anymore.  

[arun panengal]

Thanks @Kasun Bandara  yes it was related to the total power available

[kevink@cksd.wednet.edu]

Sounds like you have used all the available power that the switch can provide. Use the CLI command "show power inline" to view the POE status.