cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
307
Views
0
Helpful
2
Replies

Cisco Cat8540CSR and Cat4507R do not work in 100Mbits full-duplex mode

bugneac2
Level 1
Level 1

If connected this devices in autonegotiation mode they agree on 100M half duplex.

But I need full duplex operation.

When I put both ports in 100 full duplex the link doesn't come up....

What is the problem?

Is it an interopeation issue?

Please help.

Thanks.

2 Replies 2

sourabhagarwal
Level 4
Level 4

which interface types on both devices you are trying to inter-connect?

glen.grant
VIP Alumni
VIP Alumni

Almost sounds like you are using mdix . I would turn off mdix on both sides if supported .Make both ports either auto or hardcode both to 100 full and use a crossover cable .

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco