05-22-2012 03:21 PM - edited 03-07-2019 06:50 AM
I have a Cisco Catalyst 2960 series switch.
When I connect another switch or a VMWare Esx server on one of the ports, the port blinks for few seconds and then goes off.
When I connect a desktop or laptop or a windows server the ports stay led and I can access resources on the network. However, when connect another switch or a vmware esx server, the port is disabled.
What config in the switch can I check to make sure the ports stay on regardless when I connect a desktop / laptop, switch or vmware server?
Thankyou for your help.
Regards
-Isaac Manu
05-22-2012 03:27 PM
hi,
could u post the show run | inc interface [number] ?
it could be a spanning tree setting, like bpdu guard on the interface.
plz Rate if it helped.
Soroush.
05-22-2012 03:34 PM
Hi Isaac,
Can you post the output to the following commands:
1. sh interface
2. sh interface status err
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: