Cisco EPC3208G - SNMP

[MaCXyLooLy]

Dear Ladys and Gentlemen,

i need the MIB Table for my Cisco EPC3208G to manage this device over SNMP.

I can read out the OID's with the following command (under linux)

snmpwalk -Os -c public -v 1 192.168.100.1

That's it. Can you help me?

Thank you!

Kind Regards

MaCXyLo

PS:
Linksys says to me, that they don't support this device:

http://community.linksys.com/t5/Cable-and-DSL/Cisco-EPC3208G-SNMP/td-p/692169

[cindy toy]

Hi MaCXyLo oLyXCaM,

Thank you for your question.  However, this community is for Cisco Small Business Products and the EPC3208 is not a Cisco Small Business Product.

Your product is an internet service provider (ISP) supported product.  In other words you need to contact your ISP or technology reseller that you purchased this from to help you with your question.

Here are some links that may help you.

http://www.cisco.com/web/consumer/support/modem_DPC3208.html
http://www.cisco.com/web/consumer/support/prod_modems.html

Regards,
Cindy Toy
Cisco Small Business Community Manager
for Cisco Small Business Products
www.cisco.com/go/smallbizsupport
twitter: CiscoSBsupport

[rosaho]

This discussion has been reposted to the CSC Content with No Valid Community to Post community.