Cisco MDS 91485 16G Fiber Channel Switch

[123cmbryden]

I have 2 New Cisco Fiber Channel Switches. If I connect via HTTP will it give me a GUI or do I need a particular program. I tried using the Network Assistant but it didn't work. I know in the past with older switched we used a program but I can't remember what it was. I need to  setup zone the 2 switches together and thought I did it by command line but it's not working. I'm looking for an easier way to do it like with GUI. Is there a free program I could get or do the new switches have the GUI built in and I don't know about it? Please help me thank you,

[Reza Sharifi · Accepted solution]

It appears that you can install a client and start that way. See link below:

https://www.cisco.com/en/US/docs/storage/san_switches/mds9000/sw/fm/quick/guide/fm.html#wpxref41564

HTH

[123cmbryden · Accepted solution]

Yes this is great but how do I get the software or client?

[Reza Sharifi · Accepted solution]

Here is a link for it. You may need a CCO account.

https://software.cisco.com/download/home/282731430/type/282762464/release/5.0(7)

HTH

[123cmbryden]

Thank you for your help but I get an error. Yes I am logged in to Cisco but I get trying to get to the link.

Bad Gateway

The proxy server received an invalid response from an upstream server.

Additionally, a 400 Bad Request error was encountered while trying to use an ErrorDocument to handle the request.

[123cmbryden]

Oh I'm not sure I have a CCO account and that's probably the problem. Any other solutions?

[Reza Sharifi]

Check with others in your organization. If the switch has support, someone has a CCO account.

HTH