09-25-2018 12:17 AM - edited 03-08-2019 04:14 PM
Hello All,
Can we get wireless coverage report in site map, rogue & busiest AP detection from Prime Infra, 3.1
Thanks
Kamlesh
09-25-2018 06:33 AM
yes
09-25-2018 08:14 AM
Hi,
Can you send some reference.
Thanks
09-26-2018 12:18 AM
your question is very general, look in these guides
Cisco Prime Infrastructure 3.1 User Guide
Cisco Prime Infrastructure 3.1 Reference Guide
09-26-2018 04:17 AM
09-27-2018 01:15 AM
Hi there,
coverage failed, means that a number of clients connect to an AP with a signal strength lower than a set limit during a percentage of the session. This does not necessarily there is a real problem, or that the client can not work
It indicates fro some devices the connection may be intermittent, so not guaranteed for sustained data-flow.
cause of this may vary, but needs further investigation.
a client-session report may give information about what-clients and what access-points are involved.
or monitoring specific clients may give some information.
You need to match this with the physical location where the client is and if this is a location where wireless signal should be available you can expect that the signal is reduced if a phone is put in the drawer of a desk!
This client does not or can not switch over to another access point in, but keep in mind it is the client driver that decides to "roam" to another access-point. So not in all cases it can be solved bij adding or redistributing access points, sometimes a client driver deeds to be upgraded or configured.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: