03-03-2021 09:16 AM
Hi
How do i setup an DHCP server on my 3750x, that will work with all my private vlans?
Best greetings from Christian Josiassen
03-03-2021 01:40 PM
Hello @ChristianSchmidtJosiassen
TBH - I am now at a loss as to what the desired outcome of this - can you summarize what your request is please and if applicable attach a simple topology diagram to support it.
03-03-2021 01:47 PM
Hi
All i want is two more vlans with internet access and dhcp, one i can use for lab and another for when i have friends or family to connect their pc's up to.
03-03-2021 01:53 PM - edited 03-03-2021 01:55 PM
Hello
So then you don't require PVLAN for this, You just require two routed vlans and an acl that denies communication between them but allows internet access for both.
I assume a FW or another device is performing your L3 routing and network translation?
03-03-2021 01:57 PM
Hi
You're right my FW is performing L3 routing and network translation
03-03-2021 02:11 PM - edited 03-03-2021 02:12 PM
Hello
Then you can create the DHCP scope and the two L3 vlan routed interfaces on the FW and the have the interconnection from the switch to the FW become a trunk.
Lastly create L2 vlans on the switch that relate to the L3 routed interfaces on the FW and assign access ports to either of the two vlans..
Can you confirm what FW you have and if applicable post the current configuration of it.
03-03-2021 02:14 PM
Hi
Great how do i do that and cant i make a DHCP scope for the vlans on the switch?
03-03-2021 03:13 PM
Hello
No need you create the dhcp scope where the L3 interfaces reside, confirm what FW you have, post the run config if applicable
03-04-2021 08:07 AM
03-05-2021 01:27 PM
Hi
Got internet access to the vlans, but can't get dhcp to work in the new vlans
03-05-2021 03:29 PM
Hello
Apologies not getting to you, I assume this is on the ASA?, If so have you enable dhcp on the interface for which you wish it to run-
example:
show dhcpd state
dhcpd lease 7200
dhcpd address 10.10.10.2-10.10.10.254 vlan10
dhcpd enable vlan10
dhcpd address 10.20.20.2-10.20.20.254 vlan20
dhcpd enable vlan20
etc....
03-05-2021 03:31 PM
Hi
It's on the cisco 3750x
03-06-2021 02:23 AM
Hello
All you L3 resides on the ASA not the switch so it makes sense to apply the additional dhcp scopes on the ASA.
Can you also confirm if you created the additional L3 address for the other vlans you wish to use?
Please see attached for example:
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide