11-24-2020 12:42 AM - edited 11-24-2020 07:15 PM
I have 2 switches.
1. WS-C3650 ---> NTP Master
2.WS-C3560X ---> Client
I have configured NTP master in the WS-C3650 and set ntp server as WS-C3650 on the WS-C3560X.
3650-dot1x-test#show running-config | s ntp
ntp access-group peer 10
ntp master
ntp server 192.168.10.200
ntp server 192.168.1.254 prefer source Vlan136
3650-dot1x-test#
3650-dot1x-test#show ntp associations
address ref clock st when poll reach delay offset disp
~192.168.10.200 .INIT. 16 - 128 0 0.000 0.000 15937.
~127.127.1.1 .LOCL. 7 11 16 377 0.000 0.000 1.204
*~192.168.1.254 155.69.X.X 5 2 64 37 1.971 -46.558 6.046 -------------> This is our existing NTP master
* sys.peer, # selected, + candidate, - outlyer, x falseticker, ~ configured
3560x-dot1x-test#sh running-config | s ntp
ntp source Vlan136
ntp access-group peer 10
ntp server 192.168.10.200
3560x-dot1x-test#
3560x-dot1x-test#sh ntp associations
address ref clock st when poll reach delay offset disp
~192.168.10.200 .INIT. 16 - 256 0 0.000 0.000 15937.
* sys.peer, # selected, + candidate, - outlyer, x falseticker, ~ configured
3560x-dot1x-test#
The WS-C3560X NTP client is not able to synchronize from the Master.
11-24-2020 03:15 AM
Hello,
your NTP Master is synced with:
*~172.31.253.254
Where is IP address 172.31.236.200 configured ?
11-24-2020 05:09 AM
Can you clarify which device master - since both 3560 it confusing here. the one you posted output from client or master ?
you need to setup at client side to get associated with Server IP.
can you post both the config, along with show ntp status
or follow below guide step by step :
https://blog.noblinkyblinky.com/2019/08/02/configuring-ntp-on-a-cisco-device/
11-24-2020 07:10 PM - edited 11-24-2020 07:53 PM
Am trying to build up a new NTP master within our network. After the implementation there will two ntp masters in the network. I will ask the clients to sync to different masters by telling the NTP servers on the clients.
The NTP source to the second master will be the existing master. Is it possible? If i do that what will be the startum value for the second Master. I have attached the diagram.
Thanks in advance.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide