cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
348
Views
0
Helpful
8
Replies
ARQA-netadmin
Beginner

cisco WS-C3850-24XS stack

Hello.

 

We have 2 switches cisco WS-C3850-24XS which are collected in the stack.

Is there any ios command to switch off this stack without disconnecting cables.

We need this for activation standalone mode on each device.

8 REPLIES 8
marce1000
VIP Advisor

 

 >...We need this for activation standalone mode on each device.

                  What do you mean by that ?

 M.

We need that each device works as an independent switch.


@ARQA-netadmin wrote:

We need that each device works as an independent switch.


And introduce a "split-brain" scenario?

No. Thats the point that no split-brain.

You exec the command, the stack is sorted out and devices works correctly.

Is no such command I have to know.

 

 - If you mean long-term as 2 independent switches (again) , then it is also better to full-(factory)-reset them, and build a standalone configuration from scratch. In the end you will need separate management addressing (again) and a 'native-local' configuration (again too). The current stack-master could be used for a short-transition period as-is  , but then the same actions are recommended.

 

 M.

Leo Laohoo
VIP Community Legend

There is a command to disable the stacking ports:  

switch <1-8> stack port <1-2> disable

Will devices work correctly as standalone after this command?


@ARQA-netadmin wrote:

Will devices work correctly as standalone after this command?


I am NOT responding to a question as vague as that.