I am trying to connect a couple of clients to the internet but the problem is that they can ping the vlan of the ehwic card of the router but not the actual wan port and beyond that thus not getting a internet connection.
Below is the config you can paste into your devices that should make it work.
no ip route 0.0.0.0 0.0.0.0 Vlan1
no ip route 0.0.0.0 0.0.0.0 Vlan2
ip route 0.0.0.0 0.0.0.0 184.108.40.206
ip nat outside
interface vlan 1
ip nat inside
interface vlan 2
ip nat inside
ip access-list standard NAT
permit 192.168.10.0 0.0.0.255
permit 10.1.10.0 0.0.0.255
ip nat inside source list NAT interface g0/0 overload
no ip default-gateway 220.127.116.11
ip default-gateway 192.168.10.1
!If VLAN2 is needed on switch for example:
!switchport access vlan 2
My mistake. I meant to put after the ip route change this to whatever your ISP default gateway is. The interface in your config is set to 255.0.0.0 which could be anything. Typically you would get a /30 from a provider unless they are handing out single IP addresses from a larger block. On the ACL part it takes wildcard masks which is why I used 0.0.0.255. If you can figure out your ISP gateway and enter that in as the ip route statement then it should work no problem.
Thanks for the help so far! The switch can now ping outside the router but there is still one problem. The clients can't even ping to the router atm, they can to the switch though. The router is able to ping everything on our network and the switch too, but it seems if the clients can't get through the switch, any ideas?