I have two servers connected to Nexus, these servers are sever with windowns 2008 failover cluster. ativivo / standby.
I want the standby server 1 and server 2 becomes active it appears I can not duplicate ip, and I'm sure there is not ip duplicate.
Anyone have an idea
Thank you.
10.65.6.1 serve 1
10.65.6.2 serve 2
10.65.6.101 vip ip
CORSWBETANXS01# sh ip arp | inc 10.65.6.
10.65.6.1 00:00:15 6cae.8b2c.2d88 Vlan312
10.65.6.2 00:00:15 6cae.8b2c.2354 Vlan312
10.65.6.21 00:00:18 6cae.8b2c.2b6c Vlan312
10.65.6.22 00:00:15 6cae.8b2c.272c Vlan312
10.65.6.101 00:00:15 6cae.8b2c.2354 Vlan312
10.65.6.109 00:00:15 6cae.8b2c.2354 Vlan312 (
used for tests after ip conflict message and the message continued even changing the ip )
10.65.6.121 00:00:15 6cae.8b2c.272c Vlan312
10.65.6.202 00:00:18 6cae.8b2c.2b6c Vlan312
=======================================================
CORSWBETANXS01# sh mac add add 6cae.8b2c.2d88
Legend:
* - primary entry, G - Gateway MAC, (R) - Routed MAC, O - Overlay MAC
age - seconds since last seen,+ - primary entry using vPC Peer-Link,
(T) - True, (F) - False
VLAN MAC Address Type age Secure NTFY Ports/SWID.SSID.LID
---------+-----------------+--------+---------+------+----+------------------
* 312 6cae.8b2c.2d88 dynamic 0 F F Po5
CORSWBETANXS01# sh mac add add 6cae.8b2c.2354
Legend:
* - primary entry, G - Gateway MAC, (R) - Routed MAC, O - Overlay MAC
age - seconds since last seen,+ - primary entry using vPC Peer-Link,
(T) - True, (F) - False
VLAN MAC Address Type age Secure NTFY Ports/SWID.SSID.LID
---------+-----------------+--------+---------+------+----+------------------
* 312 6cae.8b2c.2354 dynamic 0 F F Po254
CORSWBETANXS01#
CORSWBETANXS01# show port-channel load-balance
System config:
Non-IP: src-dst mac
IP: src-dst l4port rotate 0
Port Channel Load-Balancing Configuration for all modules:
Module 3:
Non-IP: src-dst mac
IP: src-dst l4port rotate 0
Module 4:
Non-IP: src-dst mac
IP: src-dst l4port rotate 0
