I am running CNA 6.2 and all was good with the following switches.
IE-2000 (x25) switches, 2960-x (x3) switches and IE-3000(x 3) switches all playing nice.
Found out that Cisco mis-advertised/represented the capabilities of the IE3000 (No EDS File for creating tags) although this is an "Industrial Switch"
Took about 4 weeks to convince them of this fact because of course all doc's say that it can/does support EDS, but this has been proven FALSE! Even had me upgrade/down grade software checking for the EDS file....Not there period.
So, we are swapping out these IE3000 and going with IE5000. However, even tho all documents that I can find say that CNA can manage this switch, it cannot ("un-supported device").
So...more mis-direction from Cisco. Twice in as many months. Not a happy camper with Cisco.
When will these switches IE-5000-16S12P be supported in CNA, considering the documentation states that it already DOES??
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...