Command QoS in a VS-Sup2T of 6509

[rc5295509]

Hi

I Have a 6509 witch a sup vs-Sup2T,  and I´m very confuse for to configure QoS. is diferent in the old supervisor..

What is the command similar to map cos to DSCP..  look

This is a configuration in a sw 4507

qos map dscp 56 to tx-queue 1

qos map cos 1 to dscp 10

qos map cos 2 to dscp 18

qos map cos 3 to dscp 26

qos map cos 4 to dscp 34

qos map cos 5 to dscp 46

qos

In 6509 with sup2T and version 15.0.SY2  Im no sure.. I see two command

platform qos map cos-mutation testmap 4 5 6 7 0 1 2 3 

and

table-map cos-discard-class-map 0 1 2 3 4 5 6 7 

This is it..  !

I need a little help !!!

Thank

[Reza Sharifi]

Hi,

For the Sup 2T, the QOS architecture has been completely changed.  The command mls qos trus dscp is not there any more, as all interfaces by default trust cos to DSCP mapping:

if you want to see the table do a:

table-map cos-discard-class-map

More info on the sup for 2T:

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/white_paper_c11-676346.html

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/15.0SY/configuration/guide/qos_global_and_if.html

if you want to see the interface QOS info do

sh queuing interface x/x

HTH