cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1871
Views
0
Helpful
1
Replies

configure a loopback on a Gigabit Fiber port

Astronotus
Level 1
Level 1

I am trying to configure a loopback interface like so: http://www.cisco.com/en/US/products/hw/routers/ps368/module_installation_and_configuration_guides_chapter09186a0080523f70.html#wp1062339

on the following device

C3550 Software (C3550-IPSERVICESK9-M), Version 12.2(50)SE, RELEASE SOFTWARE (fc1

on port gig0/1 which is using a 1000Base-SX adapter. This is for troubleshooting purposes and it does not appear to be a feasible option.  Is there another way to accomplish in the IOS?

Thank you,

M

1 Reply 1

Reza Sharifi
Hall of Fame
Hall of Fame

The loopback command usually applies to routers.  It is not on option for this switch.

HTH

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: