07-22-2017 10:39 AM - edited 03-08-2019 11:25 AM
Hello everyone,
I am trying to configure my static
here is the config that I am using:
interface ATM0/0/0.1 point-to-point
atm route-bridged
encapsulation aal5snap
07-22-2017 11:09 AM
You need an access list to allow internal address (lan)
access-list 100 permit ip x.x.x.x x.x.x.128 where x.x.x.x is your internal segment.
also, in your NAT statement, you need to include the access list number
ip nat inside source list 100 pool NAT-POOL
Can you post "sh run"
HTH
07-22-2017 12:58 PM
12-29-2017 10:48 PM
Hello everyone,
I have figured out the issue, it turns out the address was tied to my mom's CenturyLink business DSL circuit and not to my residential DSL circuit, I have a phone call scheduled for tomorrow to call CL and have them change my address to be on my circuit and not my mom's circuit.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide