08-12-2012 11:40 AM - edited 03-07-2019 08:17 AM
Hi,
How do I configure a router to support RLOGIN incomming connections.
I configured
line vty 0 4
login local
transport input all
I have some username's confilgured in the router
when I try to rlogin to the router I get connection refused.
I did a debug. I saw the connection attempt, then the router sent back a reset (RST).
I could not find any instructions on how to configure for rlogin input connections to the router.
Thanks
Steve
08-12-2012 12:38 PM
Steve,
I understand that this is an evasive question but why would you want to use such an old and dangerous protocol to access your device? Telnet and SSH are the de-facto standards here and you should be using them instead of RLOGIN.
Best regards,
Peter
08-13-2012 12:58 PM
There may be a bug in the IOS I am using. I tried it on a different router and worked fine.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide