08-12-2012 11:40 AM - edited 03-07-2019 08:17 AM
Hi,
How do I configure a router to support RLOGIN incomming connections.
I configured
line vty 0 4
login local
transport input all
I have some username's confilgured in the router
when I try to rlogin to the router I get connection refused.
I did a debug. I saw the connection attempt, then the router sent back a reset (RST).
I could not find any instructions on how to configure for rlogin input connections to the router.
Thanks
Steve
08-12-2012 12:38 PM
Steve,
I understand that this is an evasive question but why would you want to use such an old and dangerous protocol to access your device? Telnet and SSH are the de-facto standards here and you should be using them instead of RLOGIN.
Best regards,
Peter
08-13-2012 12:58 PM
There may be a bug in the IOS I am using. I tried it on a different router and worked fine.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: