cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2102
Views
0
Helpful
6
Replies

Configure VLAN on Cisco 881

Andrew Duffield
Level 1
Level 1

Hi

I have a customer who is on thr 192.168.254.x subnet and is using a Cisco 881 as their gateway.

They wish to create a second VLAN for the 192.168.253.x subnet.

The Cisco has Dialer0 configured for an ADSL connection.

I have partly configured the router but need some assistance regarding router a device on the 192.168.253.x subnet to the internet.

Please could someone help me to configure routing to the internet on the new VLAN and assist in setting up a DHCP server on that vlan.

I have attached a copy of the current config.

Thanks in advance

Andy

6 Replies 6

cadet alain
VIP Alumni
VIP Alumni

Hi,

no ip route 192.168.253.0 255.255.255.0 Dialer0

access-list 1 permit 192.168.253.0 0.0.0.255

ip dhcp excluded-address x.x.x.x x.x.x.x    This is range of ip address you want to exclude from pool

no ip dhcp conflict logging

ip dhcp pool 253pool

network 192.168.253.0 255.255.255.0

default-router 192.168.253.254

dns-servers x.x.x.x x.x.x.x     These are the DNS servers from ISP

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

Hi Alain

Thanks for this.

In which order do I add the config?

Does the DHCP config need to be added separately?

I assume that a route isnt needed if the device is directly connected?

Cheers

Andy

Hi,

you can copy paste the commands I gave you in global configuration mode. If these devices need to go to Internet then they'll need a default gateway( either via DHCP like configured  with default-router command or via static config on the hosts)

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

Ok

How do I assign the DHCP pool to only issue IP's out of FastEthernet 2?

I am setting up a VLAN on their switch to segregate their current DHCP Server (Server 2008) from the one on VLAN 10.

Thanks

Andy

Hi,

How do I assign the DHCP pool to only issue IP's out of FastEthernet 2?

I don't understand what you mean by that ?  Can you explain further your topology

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

Hi Alain

I have an internal LAN of 192.168.254.x/24.

This has a 2008R2 server running DHCP.

They have 4 Wireless Access Points.

I want to create a separate VLAN for a guest wifi.

I want it on the 192.168.253.x/24 subnet.

The guest WAP will issue DHCP with the ip of VLAN10 as the gateway.

Does this make more sense?

Andy 

Review Cisco Networking for a $25 gift card