Connecting a printer with static IP to vlan

[Tramullo]

Hello

I have this situation and Im not sure what to do, any recommendation will be very appreciate.

I have 2 vlans:

VLAN 10 has a scope of 192.168.0.0/22

VLAN 8 has a scope of 172.16.28.0/22

The switches in the the building that connect all the jacks  are default connections to VLAN 8.

I have a printer that has a static configuration of 192.168.0.147.

If all the switch ports have a default configuration as follows:

interface GigabitEthernet3/0/29

switchport access vlan 8

switchport mode access

switchport voice vlan 20

spanning-tree portfast

What would I have to change on this port configuration to allow the printer to work on the network?

Thank you and blessings.

[cofee]

Under the interface configuration change this line "switchport access vlan 8" to "switchport access vlan 10".

[Georg Pauwen]

Hello,

in addition to cofee's post,  I would also remove the voice vlan from the port. And, obviously, exclude the static IP address from the DHCP pool...that said, how is your DHCP set up ?

interface GigabitEthernet3/0/29

description Payroll printer

switchport access vlan 10

switchport mode access

spanning-tree portfast

[Reza Sharifi]

In addition to Cofee's comment, You don't need the voice vlan for the port that is connecting to the printer.

So, it would look like this:

interface GigabitEthernet3/0/29

description Payroll printer

switchport access vlan 10

switchport mode access

spanning-tree portfast

HTH

[always.an.answer]

You don't really need the Switchport voice vlan on that port that the printer is on

config t

int 3/0/29

switchport mode access

switchport access vlan 8

spanning-tree portfast

[always.an.answer]

sorry I mean vlan 10 not 8

[paul driver]

Hello 

printer -  make sure it has a static ip of:
192.168.0.147
255.255.252.0
192.168.0.3.254  <---assuming this is your gateway address the same

on switch
conf t
default  interface GigabitEthernet3/0/29

interface GigabitEthernet3/0/29
no shut
switchport host
switchport access vlan 10

Switch & printer
make sure they are both set to the same speed and duplex setting

res
Paul