12-31-2013 01:35 PM - edited 03-07-2019 05:19 PM
I need some help connecting my WLC 4400 to my 2960 catalyst switch. The gigabit port
on the Catalyst switch I am using is connected to port 1 on WLC 4400. I have the port set to trunking
mode but I cannot ping the management interface IP. I also noticed the activity lights on the two interfaces
are not lit.
interface GigabitEthernet0/2
switchport mode trunk
Is there something else I need to attribute to this port?
Thanks
Solved! Go to Solution.
12-31-2013 02:12 PM
Hello,
It is the management interface address on the native vlan?
The management interface is left untagged so if does not belong to vlan 1 the next step is to configured the native vlan on the switch interface
switch(config)#int gi0/2
switch(config-if)#switchport trunk native vlan #
Haihua
12-31-2013 02:05 PM
Is the interface in up and up mode on the 3560?
can you issue command:
sh ip int brief gi0/2
and sh int gi0/2
Is there link light (green) on port gi0/2
HTH
01-06-2014 05:42 AM
Sorry to get back to you so late. Here is what I got.
Wireless#sh ip int brief gi0/2
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0/2 unassigned YES unset down down
Wireless#sh ip int gi0/2
GigabitEthernet0/2 is down, line protocol is down
Inbound access list is not set
It is plugged in.
01-06-2014 05:43 AM
Oh and the switch is a 2960 POE
12-31-2013 02:12 PM
Hello,
It is the management interface address on the native vlan?
The management interface is left untagged so if does not belong to vlan 1 the next step is to configured the native vlan on the switch interface
switch(config)#int gi0/2
switch(config-if)#switchport trunk native vlan #
Haihua
12-31-2013 04:24 PM
I need some help connecting my WLC 4400 to my 2960 catalyst switch. The gigabit port on the Catalyst switch I am using is connected to port 1 on WLC 4400. I have the port set to trunking mode but I cannot ping the management interface IP. I also noticed the activity lights on the two interfaces are not lit.
Make sure the WLC port is configured for LAG as well as tagged.
01-09-2014 05:27 AM
After all that it was the patch cord, boy do I feel stupid. The patch was brand
new as well. Well here is how the port was setup. And I can access the WLC gui
so I am all set.
Thanks
interface GigabitEthernet0/2
switchport trunk allowed vlan 1,10
switchport mode trunk
media-type rj45
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: