Connecting Bridge access points to a SG200-26P switch
I will be installing a wireless bridge using 1242AG access points configued as root and non-root to link two buildings.
At the non-root end the 1242 will be connected to a Cisco SG200-26P switch
and at the root end the access point will be connected to a Cisco small business pro ESW 520 24P switch
My question is this: If I double up on the access points to provide resilience/extra band-width by having 2 x root and 2 x non-root access points connected to the switches will I invoke a netowkr loop condition? And if so will spanning tree port-block one of the access point connections?
Thanks in advance. Id prefer to know whats likley to happen before trying it out on site!
I'm currently working on creating a Redundancy in two different VLANs (100& 200) having a different network. Within the two switches (IOS2-1 & IOS2-2), I configure the default gateway for access switches in HSRP VIPs, But I still can't ping VLAN 1...
Hi, I want to redistribute OMP routes to BGP, i have the doubt if all of the OMP prefixes located in the local vEdge will be redistributed to BGP or just the connected+static networks located in the vEdge. Also how can i restrict some OMP prefix...
Let's say we have two routers configured as RP candidates for auto-RP: R1 - "advertising" its loopback0 interface IP address 184.108.40.206 as the RP for these groups:220.127.116.11/3218.104.22.168/3222.214.171.124/24126.96.36.199/16 R2 - "advertising" its loopback0 int...
hi,i just performed an IOS upgrade and got a report that admin can't create L2 VLANs.i noticed the 'vtp primary force' and 'vtp primary mst' was applied to one of the core switch and perhaps got lost after the upgrade.how to keep the VTP primary persisten...