cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3875
Views
0
Helpful
1
Replies

Connecting two cisco 2960 series switch via stright trough cable causes delay in transmission!

sayedahmads
Beginner
Beginner

when i connect two cisco 2960 series switchs via stright trough cable causes delay in transmission sw1 has vlans and having trunk port connected to router all vlans are able to access internet sw2 is connected to vlan5 on switch1 sw2 has factory default  configuration computers on sw2 can access internet but I have low bandwith problem on sw2 there is transmission delay problem please help?

1 Reply 1

m.kafka
Enthusiast
Enthusiast

please use a crossover cable between switches (ports designated with X).

see article http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/hardware/installation/guide/higcable.html

if you still experince high delay/slow throughput examine bandwith, interface status, packet drops, error statistics etc...

rgds, MiKa

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: