Creating custom macros for Auto Smartports on C9200 and C9300 switches

[JMar123]

Hi,

I have successfully configured and tested the built-in Macros for Cisco devices such as phones and even used one of the built-in Macros for non Cisco IP cameras in our environment using mac address groups.

Does anybody have information or know how to build custom Macros and map the triggers to the custom Macros? I would like our switches to recognize our printers and auto assign the ports to our printer vlan.

Any info or feedback is greatly appreciated.

Thank you in advance.

[Flavio Miranda]

@JMar123 

 This guide is a bit outdated but the commands seems to be the same

https://www.cisco.com/c/en/us/support/docs/switches/catalyst-3750-series-switches/116515-configure-autosmartports-00.html