01-31-2018 10:38 PM - edited 03-08-2019 01:39 PM
Default-information originate can be used under ospf and Rip .it can not be used under eigrp. so if we have to populate a default route in eigrp what option do we have ?
01-31-2018 11:09 PM
Hi,
you can
1. configure static default route and redistibute it into EIGRP
or
2. use summary address
RTR(config)#interface gigabitEthernet x/y #outgoing interface RTR(config-if)#ip summary-address eigrp 1 0.0.0.0 0.0.0.0
Please don't forget to rate helpful posts.
regards,
mg
01-31-2018 11:36 PM
what is mean by # outgoing interface
02-04-2018 12:57 AM
Outgoing interface is the one where you want to send all traffic to. e.g. if you have a core switch connected with gig0/0 to you FW and your FW is connected to your Internet router. On the switch the outgoing interface is the one pointing to the FE (i.e. Gig0/0)
Regards,
mg
02-04-2018 03:28 AM
Hello
just like to add by default eigrp summary routes have a administrative distance of 5
so it you you have any other static routes aplli d then suggest to drop the summary default
RTR(config-if)#ip summary-address eigrp 1 0.0.0.0 0.0.0.0 1
02-05-2018 01:00 AM
To redistribute default route to EIGRP , you have to use metrics
Use following example as reference:
#Router Eigrp 1
#redistribute static metric 100000 1000 255 1 1500
you should have valid default route in your routing table as well
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: