09-27-2011 06:00 PM - edited 03-07-2019 02:28 AM
The documentation of REP says that the convergence time in a REP segment is between 200-300ms.
What is the maximum number of the devices in REP segment for that value of convergence?
Regards,
Ronaldo Gama
09-27-2011 10:59 PM
Hi Ronaldo,
This was checked with 32 devices in a ring...convergence should be in the specified range with this many number of devices....it may go up to 500ms if you plan to include many etherchannels(with many ports) in the topology.
B/w how many devices are you planning to put in a ring?
Regards,
-Ankur
09-29-2011 05:06 PM
Hi Ankur,
The customer needs to enter up to 100 devices in the ring.
The solution would be to break this ring into several sub-rings, right?
Is there any documentation that lists the number of devices in the ring with the convergence time?
Regards,
Ronaldo Gama
Enviada em: quarta-feira, 28 de setembro de 2011 03:00
Para: Ronaldo Gama
Assunto: - Re: Devices number in a REP segment
Cisco Support Community<>>
Re: Devices number in a REP segment
created by Ankur Garg<> in LAN, Switching and Routing - View the full discussion<>>>
10-04-2011 11:16 AM
Hi Ronaldo,
Can you please explain "break this ring into several sub-rings"..
Convergence should be below 250 ms for less than 64 devices in a single ring...Each ring can havce maximum 64 devices each.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: