cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
277
Views
0
Helpful
1
Replies

diagnostics commands for single switch ports on 6807

Ric Hernandez
Beginner
Beginner

Is there a command to run diagnostics on a single switch port on a line card in a 6807-XL Switch?  We have a C6800-32P10G and the LED for port 32 on that card we have all ports disabled and the other ports are solid amber/orange.  There are no SFP's in any of the ports at this time.  In an identical switch with the same model line card in the same slot (5), the LED goes green and then solid amber/orange.  That switch doesn't have any SFPs in it either and ports are administratively down like the other switch.  Is there a command I can run on that specific port to see if we have a bad port?

1 Reply 1

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend
sh interface status err
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: