Is there a command to run diagnostics on a single switch port on a line card in a 6807-XL Switch? We have a C6800-32P10G and the LED for port 32 on that card we have all ports disabled and the other ports are solid amber/orange. There are no SFP's in any of the ports at this time. In an identical switch with the same model line card in the same slot (5), the LED goes green and then solid amber/orange. That switch doesn't have any SFPs in it either and ports are administratively down like the other switch. Is there a command I can run on that specific port to see if we have a bad port?