cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

1282
Views
0
Helpful
1
Replies
Highlighted
Beginner

Dial back up on an 891

Hi There,

I am currently reviewing the 891 Router as a replacement for my 1811's in the field, but I am running into a problem with the dialer interface not working properly.

I've used what is essentially the same config from my 1811, and it works if I copy the config over line-by-line (the dialer binds, and I get a solid connection to my VPN), until I restart the router. At this point i get the errors

%Remove Dialer Profile Configuration first

%Warning:Use P2P interface for routemapset

                           interface clause

C

% Incomplete command

C

% Incomplete command

I seem to be at a loss for what this means, can someone help me out?

Thanks

1 REPLY 1

Re: Dial back up on an 891

Hi There,

I am currently reviewing the 891 Router as a replacement for my 1811's in the field, but I am running into a problem with the dialer interface not working properly.

I've used what is essentially the same config from my 1811, and it works if I copy the config over line-by-line (the dialer binds, and I get a solid connection to my VPN), until I restart the router. At this point i get the errors

%Remove Dialer Profile Configuration first

%Warning:Use P2P interface for routemapset

                           interface clause

C

% Incomplete command

C

% Incomplete command

I seem to be at a loss for what this means, can someone help me out?

Thanks

Check out the below link for configuration of dailer list in cisco 860,880 and 890 series routers

http://www.cisco.com/en/US/docs/routers/access/800/860-880-890/software/configuration/guide/routconf.html

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

CreatePlease to create content
Content for Community-Ad