cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
756
Views
5
Helpful
4
Replies

Disable Networking For Slot On Catalyst 6509-E

sean_mtich
Level 1
Level 1

Hello,

 

    Our WiSM 2 is not functioning properly and we can not bring it online without risking network downtime, so is their anyway for me to disable the networking on the Catalyst's slot so that I can plug in the WiSM 2 and work on it from serial?

 

Thanks,

          Sean

1 Accepted Solution

Accepted Solutions

Leo Laohoo
Hall of Fame
Hall of Fame
If you want to isolate the WiSM2 from the rest of the network, then remove all the allowed-VLANs.

View solution in original post

4 Replies 4

Leo Laohoo
Hall of Fame
Hall of Fame
If you want to isolate the WiSM2 from the rest of the network, then remove all the allowed-VLANs.

So how would I specify the slot after config t? I would like to be 100% sure on doing this. 

 

Thanks,

           Sean

Pick an empty slot in the chassis. I suspect since it's an empty slot, the allowed-vlans are not configured. So if this is the case then the WiSM2 is completely isolated until someone enables the VLAN on the psuedo-link.

Could you give an example command?

Review Cisco Networking for a $25 gift card